|
|
|
Step 10: You're done!
|
|
In this photo look at the top left 3 soldered connection points. The right most solder point of the three is the fixed connection. Once you have re-soldered the bad points, give your new solder a minute to harden and cool. Now you can start putting everything back together! Be sure to re-connect your 40 amp fuse. Also, once the computer is back in the car, don't forget to re-connect your negative battery terminal. Now start your car. Your check engine light should be off. You may notice the car is sputtering a little as you rev the motor, don't worry this is normal. Give the car's computer a minute to recognize the K40 relay has been fixed and it will re-adjust your fuel settings appropriately. It took my car about 3 minutes or so. Also note, you may need to re-enter the 5 digit code into your stereo since you disconnected the battery.
|
|
| Rate this file (current rating : 5 / 5 with 1 votes) |
|
|
|
|
|
|
