|
|
|
Step 7: Pull the circuit board from it's housing
|
|
Once you have separated the circuit board from the housing, gently pull it up and out. I recommend pulling out the 40 amp fuse at this point too. You may want to clean up the contacts of the fuse, I found mine to be slightly dirty. Take a screw driver or wire brush and lightly scrap away any dirt or corrosion to make the fuse conntacts shiny. Now look in the upper left hand corner of of the circuit board and follow step 8.
|
|
| Rate this file (No vote yet) |
|
|
|
|
|
|
